Building a Control PC for Barrett products

General Configuration

You should choose an operating system based on the type of PC hardware you have. The ​Shuttle PC and the ​Travla C137 PC shipped with either a Janz or esd CAN card. Newer WAMs with embedded PCs ship with a Peak CAN card. If you are ambitious, you can use your own PC and CAN card.

• Install Kernel 2.6.31.4 + Xenomai 2.5.2 (Ubuntu 9.10, Peak PCI CAN card, Xenomai SocketCAN driver) - Includes from-scratch and simple instructions, primarily for CompactFlash installation
• Install Kernel 2.6.31.4 + Xenomai 2.5.5.2 (Ubuntu 9.10, Peak PCI CAN card, Xenomai SocketCAN driver) - Simple instructions, primarily for PC hard drive installation
• Install Kernel 2.6.35.9 + Xenomai 2.6.0? (Ubuntu 10.04 LTS, Peak PCI CAN card, Xenomai SocketCAN driver) - Simple instructions for patching Ubuntu 10.04 LTS with Xenomai 2.6.0 for WAM PC Installation

Control PC Maintenance

• SoftwareUpdate - Update instructions to get the latest copy of the Barrett control software (btclient)

BarrettHand PC Requirements

The BH8-SERIES control software was written for computers running Windows XP or Ubuntu 9.10. The BarrettHand Control GUI requires a good amount of CPU power and memory for running this wxWidgets based application. Barrett Technology requires the minimum specs for using the corresponding operating system. A processor with a CPU clock speed of 1 GHz or greater, 1 GB of RAM, at least 1 GB of free disk space, and a modern graphics card is recommended. Communications requires either one available USB port for the Peak USB to CAN adapter for the BH8-280 hand or a 9-pin serial port for BH8-262 hand.