WAM Accuracy and Repeatability Study

Repeatability Test

wam_moving_towards.jpg

Figure 1: WAM arm moving towards dial indicator

wam_touching.jpg

Figure 2: WAM arm touching dial indicator

encoder_scale.jpg

Figure 3: Motor encoder scale

Encoder resolution: 40,000 counts/rev Motor resolution: 0.009 deg/count Joint 1 transmission ratio: 30:1 Ideal joint resolution: .0003 deg/count Approximate moment arm: 1 m Ideal repeatability: 0.005 mm

Repeatability Data

repeatability_data.png

Accuracy Test

single_link_pen.jpg

Figure 4: WAM - single link

single_link_closeup.jpg

Figure 5: Closeup of single link WAM

dual_link.jpg

Figure 6: WAM - dual link

Notes regarding accuracy data:

It is important to note that the repeatability data is a better measure for calibrated accuracy than is uncalibrated accuracy. Uncalibrated accuracy was measured as shown in the figures to the right. A pen attached to the outer link was used to plot points on paper taped to the floor and the WAM base was secured to the floor.

Potential sources of measurement error include:

  • the floor was assumed to be flat
  • physical measurement error with rulers & T-squares
  • physical measurement of WAM origin difficult to measure accurately

Sources of system error (calibration error) include:

  • transmission ratio errors
  • tolerance stack-up of parts
  • tool location measurement (tip of pen)

Accuracy Data

accuracy_vs_reach.png

graphs.png

Last modified 13 years ago Last modified on May 13, 2011, 2:00:42 PM