Changes between Version 3 and Version 4 of WAM/FirmwareUpdate/DetailedSafetyBoardInstructions

Timestamp:

Apr 5, 2012, 3:37:49 PM (13 years ago)

Author:

bz

Comment:

--

WAM/FirmwareUpdate/DetailedSafetyBoardInstructions

@@ -59 +59 @@
 Launch !TeraTerm/Hyperterminal (9600 baud, no parity, 8 bits, 1 stop bit, no flow control)
 
-Turn on main power to the WAM. You should get a prompt (=>). Type the following commands in sequence, each followed by <Enter>. A mis-typed command will NOT result in an error message, so type carefully! Note that this assumes you are using the stock 48 VDC power supply. Following these instructions with a different supply could damage your WAM, please contact us for custom instructions in this case.
+Turn on main power to the WAM. You should get a prompt (=>). Type the following commands in sequence, each followed by <Enter>. A mis-typed command will NOT result in an error message, so type carefully! Note that this assumes you are using a verified 48.0 VDC power supply. Following these instructions with a different supply could damage your WAM, please contact us for custom instructions in this case.
 
 1. SET X1 2000